Remove Door Panel Legacy 2012

Remove the pull handle cup.

Remove door panel legacy 2012.

Pry the snap retainers out of their seated position. There are snap retainers under the door panel that hold it in place to the door frame. Set the plastic door panel aside in a safe place. Pull out on the bottom of the trim panel right in the middle to release the bottom retainers.

4 torx t 20 speaker screws. Move the tool towards the hinge area and repeat while holding the loose portion away from the door. Most door panels will have small trim pieces located at the top of the panel at either the right or left side. These pieces must be removed before removing the panel.

The clips will unsnap and the panel will come right off. Pry against the metal portion of the door until you feel the fasteners pop. Begin to pry the door panel away from the frame starting at the bottom and working your way up each side. Lower the trim panel from the liftgate.

Press the release tab on the grey plastic electrical connector and pull it straight out of the socket on the bottom of the switch panel. Disconnect the small plastic connector clips holding the door panel in place by pulling the door panel straight out using 1 swift motion. Use the trim panel tool as your pry device. The oem door speaker is held in place to the frame by four torx t20 star bit screws.

Use a small screw driver or trim removal tool and detach pop off any trim pieces above the door panel. Here is an upper trim piece to the left of the panel. 00 04 subaru legacy outback door ajar switch sensor front driver passenger jamb. Pull outward on the edges of the lower panel to release the clips.

Free shipping on many items.