Strip both ends of wires from each sensor and twist like colored wires together.
Remove garage door sensors.
The garage door will continue to close if your steps avoid the photo eye sensor.
Open the garage door.
Loosen the nuts just.
Engaging manual mode on.
Starting with the fact it is never a good option to permanently remove the garage door sensors but at the same time bypassing it becomes a necessity.
If there is a problem with the sensor system you can over ride it temporarily by holding down the wall control button continuously until the door is closed.
The whole idea behind this article is to make you aware of the importance of garage door sensors lastly if there comes the need how to actually disable them.
Disconnecting garage door sensors.
How to bypass your garage door eye sensor with a double car garage.
The first thing you need to do is stop the power supply for the garage door.
Flip the circuit that.
How to disable a garage door sensor method 1 of 3.
Cleaning and adjustment remove any debris dust or cobwebs from the electric eye lenses on each sensor with a clean rag.
Attempt to close the garage door using a remote.
Press the garage door opener wall button to fully open the garage door.
Remove the sensors from the brackets.
Loosen the small nuts that hold each sensor to the l brackets with a small adjustable wrench.
In fact the safety system is considered so important that in most areas it is required by law.
Disconnect the power to the garage door.
If you have an automatic garage door then you have to disconnect the door sensors.
You will still be able to use the doors by manually opening or closing it.
Adjust each sensor in small.
Remove the wires from the wire nuts or cut the sensor wires 12 from the sensors.
Proceed with both sensors to the garage door opener motor unit.
How to bypass a garage door sensor step 1.
Disconnecting the garage door opener from the garage door will bypass the sensors.
Disconnect the emergency release cord.
The safest way to bypass a garage door.
Cycle the garage door.
If you release the button before the door is fully down it will still reverse back open.
The emergency release cord.
Operate the garage.
Setting the door to manual mode.
The door should stay open and the motor unit lights should blink.
Since most photo eye sensors are placed at that two inch height most people know you can simply step high above the infrared light to bypass the system.