Remove Jeep Doors With Power Windows

Try putting the nuts on but just a couple turns and put a wrench on the nut and hit it the wrench with a rubber hammer and when you get the doors off put some bearing grease on the hinge and that will keep them lubed and easier to remove next time but remember to clean and regrease often.

Remove jeep doors with power windows.

The nuts are painted to match the body of the jeep so be very. The process is basically the same for the front and rear. Instructions 1 remove the door panel. 2 pull or cut out the glued door seal to allow access inside the door.

Be careful with the paint on the door hardware. At the bottom of each of the two bolts that hold each door on the. See more information on our jeep wrangler power window kit power door lock kits. Roll down the windows remove the door check arm unplug the wiring drop the two hinge bolts pull off the limit strap and lift it free.

Simple 3 wire hookup. It s also beneficial to lube the door stems and hinges when the doors are removed in order to make future removal easier. Use a 13 mm socket and turn counter clockwise to loosen the nuts. This can be done with a t50 socket and ratchet.

The first step in the removal of jeep doors is to loosen and remove the t50 cap nuts on the door hinges. Lift the door straight up to disconnect it. Once you ve removed the nuts reach through the open window to grip the inside door handle. With the other hand grip the outside door handle.

Be careful not to damage the paint. Removing the doors 1. One power wire goes to the battery one goes to an ignition power source and the third gets grounded in the kick panel. Remove the nuts on the bottom of each bolt.

If you need more information on how to do that check out the door panel removal video.