To remove a door handle without any visible screws start by prying off the cover plate by inserting a flathead screwdriver in the notch on the side of the plate.
Remove old door handle without screws.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
After all you can t restore old hardware unless you can first get it off the door or window it s attached to.
If the knob has a recessed setscrew turn the setscrew counterclockwise with a correctly sized.
Next find a small slot on the edge of the trim piece.
If you don t see a notch and the cover plate is round try turning the plate counterclockwise to remove it.
Locate the hole underneath the doorknob shaft.
Take your flat philips screwdriver and place it in the gap.
With some pressure you can move the clip inside.
Old flat head screws that have been attached for close to a century can be tortuously difficult to remove.
The door handle will now slide off.
Our quick video shows you how si.
Last week i talked about how to remove paint from hardware so in keeping with that theme i wanted to discuss some tips to remove stubborn screws.
Straighten a paper clip and insert it into the hole.
You should see a tiny slot or hole.
Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.
There should be a small latch near the base of the knob or handle probably on the exterior side of the door.
This is a simple straig.
Depending on the door handle design the faceplate may be able to slide completely off.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
Slide the cosmetic faceplate away from the door.
How to remove door knob without screws look for the tiny gap on the side of the door knob.
If not rotate the faceplate until the underlying screws are accessible and use a phillips head screwdriver to remove them.
Insert the tip of a screwdriver and pry off the trim piece.
After applying some pressure you can pull the door knob towards you.
Once triggered the lever or lock trim can be removed from the door.
Tug on the knob and it will slide right off.
Look for a thin slot or a recessed hex head setscrew on the lock side of the doorknob.
Push the tip of a narrow screwdriver into the hole.
