Avoid plastic drop cloths which.
Remove textured concrete wall.
When you begin removing textures from your wall it is given that there will be a lot of dust and wall chips that will be flying off from the wall so it is only obvious that you cover the room well and if possible remove any fabric based furniture out of the room.
Removing plaster and render my way learn how i hack of old render from the concrete block wall getting it ready to be plastered with sand and cement render.
Make sure it s completely clean before to get to the next step.
Hold a floor scraper or drywall blade at a 30 angle.
Adding water would not soften stucco or similar compounds.
Either way depending on the height of the texture on your walls it is likely possible to skim coat the walls with drywall mud sand and paint.
Break the concrete wall into small chunks with your preferred tool and let the debris fall to the ground as you work.
Skim coating a whole room is both messy and time consuming.
Then use sandpaper to smooth out any uneven or textured areas.
On an unpainted drywall ceiling the way way to remove texture is to spray it with water and scrape it.
Set the blade against the wall.
The blade should create a 30.
You may have to spray the wall.
The same technique gets rid of textured walls.
Especially bumpy walls may need more than one coat.
Cover the room well.
First spray a spot and wait for the water to soak in and then scrape at an angle.
The texture can be impossible to match when repairs in your wall are necessary.
Soak and scrape unpainted texture to prep and protect cover the floor with a canvas drop cloth and tape up exposed trim.
Scrape off the texture.
Ignore any rebar you come across and just break the concrete free of the metal.
Fill a pump sprayer with water and spray the entire wall evenly to soften the texture.
Start with a 2 by 2 feet 0 61 by 0 61 m square and thoroughly coat it with water.
Instructions to follow to remove the texture from walls 1.
A thin coat of mud is applied over the entire wall surface allowed to dry and then sanded smooth.
Spray a small area with water.