Stand next to the.
Removing dents in garage door.
You want the water sudsy.
Unroll and cut a piece of aluminum foil from the roll that is long enough to completely cover the dent in your.
Swirl the water and dish soap with a sponge to mix.
Put a strip of aluminum foil over the dent.
Use the sponge with the water and detergent to wash the dented area of the door thoroughly.
Thoroughly wash the dented area with a sponge and remove all of the dirt.
Next grab your fine grit sandpaper.
Make sure the area and clean and dry before you move on.
Place a layer of aluminum foil over the dent.
In this step you ll sand the area to produce a smooth leveled.
After a minute remove the foil and spray the dent with the compressed air upside down for about 30 seconds.
3 use the 120 coarseness sandpaper on the indented side.
Fill the bucket with warm water from the hose and add the dish soap.
How to repair garage door dents step 1.
1 wash the area with warm water and detergent and then allow for it to dry.
All dirt and grime must be removed for this procedure to work.
Unroll enough foil to cover the dent and to give you room to hold the foil at each end.
A secret tip to fix a dented aluminum garage door 1.
Fill your bucket with warm water and add a small amount of dish soap.
Cut the piece of foil from the roll and keep it within reach.
Take a sheet of foil which covers an area slightly.
Use the heat source so it evenly heats up the foil.
Wash the area with warm water and detergent and allow it to dry completely.
Steps to repairing garage door dents clean the problem area.
Your next step will be cleaning the problematic area with warm water and a mild detergent such.
Fill the bucket with water and add some dishwashing detergent.
Taking the sponge wash the dented area completely.
Dry the washed area of the door.
7 ways to fix a dent in a garage door panel paint a block of wood 80 and 120 grit sandpaper rubber mallet cardboard auto body filler plastic putty knife.
Fill a bucket with water and add 1 teaspoon of dish soap.
2 place the wooden block over the dent and tap lightly and slowly with the mallet to flatten the surface.