Removing Shower Door Bottom Track

Lift the track out from between the vertical tracks.

Removing shower door bottom track.

You have removed the door. Lean the bottom of the door towards you as the top of the door remains in the top track. Stand inside the shower. Use an old cloth and apply the paste to all the shower door tracks.

The track should only be held down with some type of silicone and will come up with a little coaxing. After that repeat the process with the new amount of paste. Then go to the paint or flooring department at your local home depot for some epoxy remover to clean the area. The bottom track is made from aluminum and will have one edge shorter than the other.

Tired of your old outdated glass shower door. This simple tutorial will totally transform your bathroom for only 2. After removing the screws if there are any use a 5 in 1 tool to break the seal at the edge. Standing in the shower grasp the inside shower door with both hands halfway up on the both sides.

Grasp the near door with both hands and lift the door. Step 1 remove a sliding door. The bottom of the door will lift high enough to clear the inside edge of the track. After approximately 30 minutes wipe wet dirt and soap scum off with a new damp cloth.

4 use the putty knife to scrape away silicone. Pull off the bar at the top. Don t know what a 5 in 1 tool is. One the other hand the top track and top of the door is where you will find the roller wheels.

Lift the door straight up and tilt the base of the door toward you while leaning the top of the door out of its track. Cut the beads of silicone both inside and outside that hold the lower track to the shower pan. A sliding shower door is the easiest of the two styles to take out of its frame as there is nothing to actually remove. Watch how to remove a glass shower door safely and without breakage from a tub or shower space.

Lower the door to clear the top track. Most shower doors slide out on the inside of the stall so this is where you have to be. If the dirt layer is too thick you should use a metal scraper or knife to remove some of it. Just lift up to pull them from the track at the bottom and remove.