If you are removing an entire wall of tiles just make sure to remove grout next to the ceiling and floor.
Removing tile from sheetrock wall.
When removing a single tile remove the grout on all sides of it to avoid damaging the others around it.
The use of the right tools and materials combined with some elbow grease will remove most tile adhesives from drywall.
Thinset mortar is generally used as the adhesive when tiling a wall.
The method used to attach the tiles to the wall affects the way the tiles come off.
At the edge of the.
If you re working with an existing tile wall you have two choices.
If existing tiles are beyond repair remove the tile and install a piece of wallboard in its place.
If chunks of drywall are coming off with the tiles however save yourself some trouble and remove the sheetrock with the tile.
If the tile runs wall to wall proceed to step 2 to create your starting point.
Removing tile adhesive from drywall is not an impossible process.
Remember to keep your sink covered at all times.
Remove outlet covers and cut the electricity to the area where you will be removing the tiles.
When replacing tile on drywall it is necessary to prepare the surface so that the new tile adheres properly.
Wipe down the wall using a damp sponge to remove any dust.
Find or create a starting point.
When the old tile.
Once you have tools and materials on hand it s time to begin the process.
When removing tile from drywall take care not to damage the wall underneath.
By locating wall studs outside the tile perimeter and cutting through.
If there is an outside edge to the tile you can start there.
Remove the tile and prepare the wall according to the corresponding instructions above or tile over the existing tile.
Clear the counter so you will have easy access to the backsplash.
To do so make sure all of the tiles are intact and secure.
Move the spreader down the face of the tile to remove any excess grout leaving a indentation between the tiles about the depth of your thumb tip.
Repair any loose or cracked tiles.
Carefully use the hammer and putty knife to chisel off the tiles.
A wet vac is very useful removing the excess dust and debris.