Ring Doorbell Battery Charge Lights

Loosen the security screw on the base of the doorbell and lift the faceplate up and away from the wall.

Ring doorbell battery charge lights.

Once charged only the green light will be on. When the ring fills all the way up then the battery has been charged to 100. Your battery is fully charged when the light on the battery shines a solid green. Open the battery compartment press the white button and lift open.

Open the ring app and tap your ring doorbell to open its settings screen. Remove the battery by pressing the release tab. Your battery is fully charged when the light on the battery shines a solid green. Remove the battery by pressing the release tab.

The blue led ring light around the doorbell button will light up and show the status of how charged up it is. If it reads good or very good then your ring doorbell is receiving sufficient power and you ll have to find another cause for your issue. Take a look at the voltage reading. It will take a few hours to charge it up especially if the battery was nearly dead.

Connect any micro usb charger to the charging port in the back of the ring unit an orange charger comes inside your ring box. After about 30 seconds time for the ring doorbell to start up test your ring doorbell by pressing the button on the front. Loosen the security screw on the base of the doorbell and lift the faceplate up and away from the wall. To recharge your ring doorbell.

This indicates that your ring 2 is charging properly. Tap the device health tile. Remove the security screws on the base of the doorbell and lift the doorbell up and away from the mounting bracket. Connect the orange micro usb charger to the charging port in the battery.

A 2 1 amp wall charger such as an apple iphone wall adapter will charge your ring 2 the fastest usually within 5 hours. Connect any micro usb charger to the charging port in the battery. Confirm that its charging by looking at your ring 2 battery to see if both the orange and blue lights are lit up. Reattach the ring unit to the mounting bracket using your security screws.

Reattach the ring unit to the mounting bracket using your security screws. Connect any micro usb charger to the charging port in the battery. Connect any micro usb charger to the charging port in the battery. If you ve put the battery back into the doorbell when you had the solid green light and you are getting no response from the doorbell no signs of light on the ring around or even after your press the setup button then you may be looking at a battery concern.

During charging both the red and green lights will light up. Your battery is fully charged when the circular light on the front of your ring device is a solid blue circle. Remove the battery by pressing the release tab. Slide the fully charged battery back into the video doorbell 3 plus until it clicks in place.