Your battery is fully charged when the light on the battery shines a solid green.
Ring doorbell charging lights.
Charging your ring 2 with a computer can take up to 10 hours.
Once charged only the green light will be on.
To recharge your ring doorbell.
Slide the fully charged battery back into the ring doorbell.
To recharge your ring doorbell.
Connect any micro usb charger to the charging port in the back of the ring unit an orange charger comes inside your.
The micro usb cable can be plugged into any usb power source such as a computer.
To charge your ring doorbell 2.
Remove the security screws on the base of the doorbell and lift the doorbell up and away from the mounting bracket.
During charging both the red and green lights will light up.
To charge your ring doorbell.
I charged mine up when it was at around 60 and it took about an hour.
If you would like to avoid charging your battery by directly connecting your ring video doorbell to a transformer it s possible if you don t have an existing doorbell.
The blue led ring light around the doorbell button will light up and show the status of how charged up it is.
A 2 1 amp wall charger such as an apple iphone wall adapter will charge your ring 2 the fastest usually within 5 hours.
Connect any micro usb charger to the charging port in the battery.
Your ring video doorbell is charged using a common micro usb cable an orange one is included in your ring box.
There will be a click when the battery is secure.
Problems can arise however when a doorbell mechanism draws so much power that there s not enough left over to power your ring video doorbell pro.
This indicates that your ring 2 is charging properly.
Your ring video doorbell will take around five to 10 hours to fully charge.
If you ve put the battery back into the doorbell when you had the solid green light and you are getting no response from the doorbell no signs of light on the ring around or even after your press the setup button then you may be looking at a battery concern.
This article will tell you how to connect a ring doorbell directly to a low voltage 8 24v ac transformer.
Remove the battery by pressing the release tab.
Slide the fully charged battery back into the video doorbell 3 plus until it clicks in place.
Your battery is fully charged when the light on the battery shines a solid green.
When the ring fills all the way up then the battery has been charged to 100.
After about 30 seconds time for the ring doorbell to start up return the faceplate to the ring doorbell and secure it.
Your ring video doorbell pro is designed to draw power from the same 16 volt ac power transformer as your internal doorbell mechanism.
Your battery is fully charged when the light on the battery shines a solid green.
Loosen the security screw on the base of the doorbell and lift the faceplate up and away from the wall.
Remove the security screws on the base of.
