Re Roofing A House Building Regulations

Proof of house ownership a statement of repair stating that you will keep the building codes in consideration construction design and elevation drawings of the house.

Re roofing a house building regulations.

You carry out structural alterations. The project of re roofing will be approved if you provide. Select the required size and type of shingles to be used in the process. You carry out structural alterations.

If you want to carry out repairs on or re cover less than 25 per cent of the area of a pitch or flat roof you will not normally need to submit a building regulations application. When a reference is made within this rule to a federal statutory provision an industry consensus standard or any other technical publication the specific date and title of the publication as well as the name and address of the promulgating agency are listed in rule 4101 8 44 01 of the administrative code. The development rules allow for roof alterations subject to the following limits and conditions. Again the minimum standard is that bs 5534 must be met and construction design and management cdm regulations now apply to domestic re roofing which put health and safety obligations on the contractor.

Not to mention that the homeowner could end up with a roof that has not been lawfully approved which may affect their home insurance. Alterations should not project more than 150 millimetres from the existing roof plane. It is not normally necessary to apply for planning permission to re roof a house or to retrofit rooflights or skylights. You will need approval however if.

It appears that there are some roofing contractors who are unaware of this requirement and are simply re roofing houses without proper building approval which can place their qbcc licenses in jeopardy. This is so an appointed building inspector can check various key areas of work including ventilation and loft insulation thickness. Chapter 4101 8 9 roof assemblies. If you are re roofing the whole property or more than a quarter of the roof area then you will need to submit a building regulations application form to your local authority.

If you want to carry out repairs on or re cover less than 25 per cent of the area of a pitch or flat roof you will not normally need to submit a building regulations application. Alterations should not be higher than the highest part of the existing roof. If the existing roof covering is to be replaced with a different material to its original for example slate to tiles then approval under the building regulations is likely to be needed to ensure the roof will be adequate in terms of structural stability applicable where the replacement tile will be significantly heavier or lighter than the existing and also meets requirements in respect of fire safety and energy efficiency see above. These are also reflected in hsg 33 health and safety in roof work from the hse.

You will need approval however if.