Turn off the water supply to the fixture at the two small water valves mounted on the wall beneath the sink.
Repair unattached trip lever in wall mount sink.
Note the hexagonal escutcheons and metal cross handles.
The plunger piece provides the plug in the sink s drain assembly keeping the water that runs into the sink from draining out.
Lift up the sink.
The floor sink should be placed in front of the plumbing.
While it uses the same faucet handles as the previous version the spout is changed to a metal version and the trip lever for the drain rotates behind the spout.
Step 2 place a small bucket on the floor beneath the water valves to catch any water left in the lines then disconnect each of the lines with an adjustable wrench.
Also the appearance of the sink is changed to something a bit more modern.
You must detach the plunger from the sink s drain assembly in order to clear out large clogs or to replace the rubber pad on the underside of the plunger.
Slide the clevis about 2 inches along.
You should now see screws holding the bracket to the wall.
Exposed pipes are not aesthetically striking.
Check with the diagram and specifications of the floor sink before doing anything to the existing wall mounted sink.
The plumbing should have an accurate position.